MYTEE 3601 SYSTEM MAINTAINER
After purchasing one or more Mytee® extractors, make the most of your good investment by ordering our System Maintainer. Use Mytee's System Maintainer regularly for maximum performance and pressure and to prolong the life of your machine.
Benefits of using System Maintainer
Keep all tanks and lines free of hard water and chemical buildup
Improve pump life
Minimize corrosion and scale buildup for maximum performance and pressure
Keep the heater(s) running at maximum temperature
Learn more about the importance of the system maintainer here.
System manager operating instructions
Thoroughly mix System Maintainer with lukewarm water at a ratio of 1:1 in a separate container. Pour into the solution tank of your extractor.
Connect a cleaning tool (upholstery tool, wand, etc.) and remove the jet(s) to prevent clogging from dislodged mineral buildup.
Turn on the extractor pump and run the system maintenance solution through the system and into a bucket or container until you have a solid stream.
Let it sit for about 5 minutes while the system maintenance solution does its job inside your extractor.
Finish running the rest of the solution in the system.
Run clean water through the system to flush out any remaining System Maintainer. Use Mytee's System Maintainer regularly for maximum performance and pressure and to prolong the life of your machine.
Benefits of Using System Maintainer
Keep all tanks and lines free of hard water and chemical build-up
Improve pump life
Minimize corrosion and limescale build-up for maximum performance and pressure
Keep heater(s) running at maximum temperature
Read more about the importance of System Maintainer here.
System Maintainer Instructions for Use
Thoroughly mix System Maintainer with warm water at a 1:1 ratio in a separate container. Pour into your Extractor's solution tank.
Connect a cleaning tool (upholstery tool, wand, etc.) and remove the jet(s) in order to prevent clogging from dislodged mineral build-up.
Turn on the Extractor's pump and run the System Maintainer solution through the system and into a bucket or receptacle until you have a solid stream.
Let sit for about 5 minutes while the System Maintainer solution does its job inside your Extractor.
Finish running the rest of the solution through the system.
Run clean water through the system to flush out any remaining System Maintainer.